Shimpo SE-G2 SE-G2 Proximity Sensor
(No reviews yet)
Write a Review
Write a Review
Shimpo Instruments
Shimpo SE-G2 SE-G2 Proximity Sensor
$130.00
- Brand
- Shimpo Instruments
- SKU:
- SE-G2
The SE-G model is a solid state proximity switch especially designed for gear sensing. The SE-G model gear sensor will provide a square wave signal output and indicate detection via LED indicator on rear of unit. Maximum switching frequency is 8 kHz with a maximum sensing distance of 1.0 mm, gear pitch must be between 25.4 (min) and 16.93 (max).
0 Reviews Hide Reviews Show Reviews
Shimpo Instruments
Shimpo MCS-3109 Proximity Sensor for Use in High Vibration Areas
$225.00
DescriptionThe MCS-3109 is complimentary (NPN-NO and NPN-NC) proximity sensor normally used in high-vibration areas and where a greater sensing distance is required.Features:NPN (NO, NC) output300 Hz...
Shimpo Instruments
Shimpo DJ2-G 2-wire Proximity Switch
$45.00
Description
Proximity Metal Sensor
Features
NAMUR output
3 kHz frequency
Zero-sensing capability
6.5? (2 m) cable
0.08? (2 mm) sensing distance
NEMA 6 (IP67) rating
Economical solution...
Shimpo Instruments
Shimpo E2E-X5ME1-Z E2E-X5ME1-Z Proximity Sensor with M-16, 3-Pin Connection for ST-300 Series Stroboscopes
$35.00
DescriptionProximity Sensor for ST-300 StroboscopeProximity Sensor with M-12 3-Pin Connection for ST-300 Stroboscope
Shimpo Instruments
Shimpo E2E-X5ME1-Z-USB Proximity Sensor with USB Connection for ST-320BL & DT-366 Series Stroboscopes
$35.00
DescriptionShimpo, E2E-X5ME1-Z-USB, Proximity Sensor with USB Connection for ST-320BL
Shimpo Instruments
Shimpo CABLE-3030 Cable for 3030AN Sensor
$59.00
DescriptionCable for 3030AN Magnetic Pick-Up Sensor
Shimpo Instruments
Shimpo XP12010 Explosion Proof Magnetic Sensor
$575.00
DescriptionSpecifically engineered for use in the oil and petrochemical industries, this stainless steel sensor is completely sealed and explosion-proof. Low impedance allows for transistor circuit...
Shimpo Instruments
Shimpo 3030AN Magnetic Sensor, Requires CABLE-3030AN
$80.00
DescriptionMagnetic Pick-Up SensorFeaturesSine wave output from change in magnetic to non-magneticChange in voltage proportional to magnetic flux intensity over timeRange of 0.01? (0.25 mm) typical...
Shimpo Instruments
Shimpo MP-10 MP-10 Magnetic Sensor
$120.00
DescriptionMagnetic Pick-Up SensorMP-10 Magnetic Pick-Up Sensor provides a sine wave output whenever there is an abrupt change from non-magnetic to magnetic material moving past the sensor pole. The...
Gas clip technologies
Gas Clip Technologies MGC-SE-O2 Multi Gas Clip O2 Replacement Sensor
$140.00
Gas Clip MGC-SE-O2 Description Replacement O2 sensor for Multi Gas Clip Infrared, Multi Gas Clip Pump infrared, Multi Gas Clip Pellistor &...